next »

[aspanrt]

I have a 383 i'm putting together after 10yrs of sitting on bench and i need some help id.ing a part. It's round stamped steel and from the hole u can tell it goes over crank i'm guessing between timing chain and cover but not sure which way it goes? Any help would be appreceated. I feel like a fool for not remembering..lol..

[thumbuster]

been a few years but if I remember right it goes on with the outer edge away from you or towards the timing gear.  It acts as a slinger to keep the oil from splashing onto the front seal.  Check this out with someone else as I said, it's been a long time since I was into one.  FYI, I was certified Master Mechanic for many years but got out of the field and into heavy equipment many years ago.
Hope this helps

[crug75hid]

you are right probably. had heard about the same past some months and the issue was same. in between timing chain and cober

[aspanrt]

Cool i thought that was were it went. But wasn't positive. Thanks

[268RTs4ME]

slipd on after your crank gear,is a slinger